Modine Noisy Sep 30, 2016

After waiting 26 days to get my Effinity 93 110000 btu unit, I installed it only to find out the propeller fan was very noisy. It is louder than my air compressor. Modine will not honor the warranty unless you use a professional installer. If you are a do it yourselfer, don't buy this unit. The propeller motor is cheap and creates a lot of vibration noise. Even if the motor was replaced under warranty, it would still be the same noisy motor. If you want to be able to talk in the vicinity... more

Really Nice Heater At A Great Price Sep 01, 2016

I actually bought 5 Pensotti Wall Panel Radiators, 3 of the 20" x 24" and two of these 20" X 48" units. They are replacing hot water baseboard heaters in a basement apartment. These heaters are stylish, extremely efficient and are priced very nicely. Installation was a snap using the included hardware, HOWEVER, I highly recommend purchasing an extra set of brackets for the 20" x 48" heater due to its weight. I used 3 brackets on each heater for a rock solid... more

Homeowner Dec 01, 2016

eComfort is very a professional company. They answered all questions quickly and thoroughly. The product was delivered incredibly fast. The quality of the product is exceptional. It is solid, streamlined, very well crafted and very easy to install. It was used to replace a standard baseboard unit at the end of a run in a room that was consistently 10-20 degrees colder than the rest of the house in the winter. When the system was tested after install, the difference was immediately... more

Runtal Uf - 7,200 Btu - Hydronic Baseboard Radiator - 6" H - 144" W - 2" D Review Apr 20, 2016

Expensive but is a nicely manufactured product.

Nice Choice Aug 05, 2016

The radiators went together very easily with the connections provided to the heating pex and there were no leaks. very easy to bleed. they provide much more heat than I was getting from my old wall convectors and seem to retain the heat a long time after the boiler is off. Not hard to hang either as long as you separate the hanger prongs in increments of 1/2 inch. Also, my wife was pleasantly surprised by the appearance