Warmwire Heated Floor Jun 07, 2016

I installed a WarmWire heated floor in a 6'x8' coat room that had no other source of heat. It is on a concrete slab with 2 outside walls and a wall to an unheated attached garage. I glued 2 6mm thick sheets of Cerazorb synthetic cork directly on the concrete. It was super easy to lay the wire on top on the cork using the metal clip system provided. To be safe, I laid a sheet of 1/4" luan plywood on top of the wires while laying the tile. I checked the resistance in the wires at each step... more

Really Nice Heater At A Great Price Sep 20, 2016

I actually bought 5 Pensotti Wall Panel Radiators, 3 of the 20" x 24" and two of these 20" X 48" units. They are replacing hot water baseboard heaters in a basement apartment. These heaters are stylish, extremely efficient and are priced very nicely. Installation was a snap using the included hardware, HOWEVER, I highly recommend purchasing an extra set of brackets for the 20" x 48" heater due to its weight. I used 3 brackets on each heater for a rock solid... more

Nice Boiler Oct 02, 2016

Installed my B10/4 with a becket burner, just over a month ago. I am very pleased with it so far. Have a tank for hot water and it heats the tank quickly. I have only had to run it a couple of times to take the chill off the house, but it did so well. It is quiet, light weight. The weight was nice since I have no outside access to my cellar, and had to bring it thru the house and down a flight of stairs. Too early to talk about fuel savings, I'll update the post later, but so far very... more

Well Made Heater Oct 20, 2016

This heater was easy to install, it is made of high quality metal. Nice to have power connections on both sides of the heater and ample amount of heat.

It's Great - Very Simple Nov 20, 2016

Been looking for a simple thermostat, but I couldn't find one at most stores. It's just what I wanted, and more. Thank you.